These switches have two traveler wires and a single common wire.
Wiring receptacle to switch to light.
Switch box wiring at the switch box the white neutral wires are spliced together and the ground wires are spliced and a pigtail wire is added and attached to the green ground screw on the light switch frame.
Is it possible to wire a switch for a light and at the same time connect an outlet to the switch that will not power off and on with the switch.
Now that the light switch is completely removed we ll need to prepare for the installation of the combo switch.
As you can see connecting a receptacle to the light would see the receptacle only hot when the light switch is on.
Mike a handyman from fort dodge iowa.
Three way switches control a light fixture or outlet from two different locations.
Also included are wiring arrangements for multiple light fixtures controlled by one switch two switches on one box and a split receptacle controlled by two switches.
The second method of wiring a mid run receptacle is to connect the receptacle to the circuit wires with pigtails that tap into the circuit wires passing through the box.
Normally when you replace a light switch you would leave the neutral wires alone but in this case we ll be connecting them to the new combo switch.
The incoming power from the outlet is attached to one of the light switch screw terminals and the black wire of the cable leading to the.
You ll need access to the white neutral wires.
Here is what you would have to do if possible change out the 2 wire to 3 wire cable from switch to light.
In this case the circuit load flows both to the receptacle and to any downstream receptacles without being dependent on flowing through the receptacle s connecting tab.
Now remove the wire cap from the two white wires in the box add the white wire from the outlet and reset the cap.
Wiring a switch loop when the electrical source originates at a light fixture and is controlled from a remote location a switch loop is used.
Remove the black line wire from the switch twist it together with the black wire going to the receptacle and add a six inch length of black wire of the same gauge.
You can change this duplex receptacle to a switch receptacle combination so that you still have power in the outlet but can use the switch to control your new overhead task light.
The trick to replacing a three way switch is to mark the common or com wire on the old switch before removing the wires.
Fishing in a wire from the receptacle to the light fixture is fairly easy so this is how you would wire the switch receptacle combo device in this situation.
In this case you must change the cable from the switch to the light outlet from a 2 wire to a 3 wire cable.
Connect this jumper wire back to the switch terminal.
Wrapping the wire clockwise when wiring a light switch ensures that the loop on the end of the wire will tend to close when the screw is tightened.
